FixVault
Home › Hyundai › 2006 › Elantra Limited › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle System (F4A42) › Automatic Transaxle Control System › Input Speed Sensor › Installation

Input Speed Sensor: Installation

  1. Apply a light coat of automatic transaxle fluid to the O-ring seal before installation.
  2. Install the input shaft speed sensor.
  3. Install the control cable mounting bracket.
  4. Connect the input shaft speed sensor connector.
  5. Install the clip of the control cable.
  6. Adjust the control cable to transaxle range switch and tight the transaxle manual lever to the control cable mounting nut. (See TRANSAXLE RANGE (TR) SWITCH  )
  7. Installation is the reverse of removal.
About FixVault