FixVault
Home › Hyundai › 2006 › Elantra Limited › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle System (F4A42) › Automatic Transaxle Control System › Input Speed Sensor › Removal

Input Speed Sensor: Removal

  1. Removal of the battery and air cleaner (see TRANSAXLE RANGE (TR) SWITCH  .
  2. Remove the transaxle range switch connector.
  3. Remove the control cable to transaxle range switch mounting nut.
  4. Remove the clip (A) of the control cable (B).
    Fig 1: Identifying Control Cable And Clip
    G04811351Courtesy of HYUNDAI MOTOR CO.
  5. Remove the control cable mounting bracket.
  6. Remove the input shaft speed sensor (A).
  7. Disconnect the input shaft speed sensor connector.
  8. Remove the bolt (B).
    Fig 2: Identifying Shaft Speed Sensor And Bolt
    G04811349Courtesy of HYUNDAI MOTOR CO.
  9. Inspect the input shaft speed sensor bore.
About FixVault