FixVault

Power Circuit Inspection

  1. IG "OFF"
  2. Disconnect Main Relay
  3. IG "ON" & ENG "OFF".
  4. Measure voltage between harness terminal 2 of Main Relay and chassis ground.
  5. Measure voltage between harness terminal 5 of Main Relay and chassis ground.

    Specification: B+

  6. Is the measured voltage within specification?

    YES 

    NO 

    • Check fuse between battery and main relay is disconnected.
    • Repair or replace open or short in harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.