Power Steering Oil Pump: Disassembly

Remove the bolts from the oil pump body, and then remove the suction pipe (A) and O-ring.

Fig 1: Identifying Suction Pipe And O-Ring
Courtesy of HYUNDAI MOTOR CO.
Remove the power steering oil pump rear cover (A) and the O-ring (B) by removing the four bolts.

Fig 2: Identifying Power Steering Oil Pump Rear Cover And O-Ring
Courtesy of HYUNDAI MOTOR CO.
Remove the snap ring (A).

Fig 3: Identifying Snap Ring
Courtesy of HYUNDAI MOTOR CO.
Remove the cam ring.

Fig 4: Identifying Cam Ring
Courtesy of HYUNDAI MOTOR CO.
Remove the rotor (B) and vanes (A).

Fig 5: Identifying Rotor And Vanes
Courtesy of HYUNDAI MOTOR CO.
Remove the oil pump side plate (A).

Fig 6: Identifying Oil Pump Side Plate
Courtesy of HYUNDAI MOTOR CO.
Remove the inner O-ring (A) and outer O-ring (B).

Fig 7: Identifying Inner O-Ring And Outer O-Ring
Courtesy of HYUNDAI MOTOR CO.
Remove the drive pulley (A).

Fig 8: Identifying Drive Pulley
Courtesy of HYUNDAI MOTOR CO.
Remove the oil seal (A) from the oil pump body.

Fig 9: Identifying Oil Seal
Courtesy of HYUNDAI MOTOR CO.
Remove the connector (A) from the oil pump body, and take out the flow control valve (B) and the flow control spring (C).

Fig 10: Identifying Connector, Flow Control Valve And Flow Control Spring
Courtesy of HYUNDAI MOTOR CO.
Remove the O-ring from the connector.
CAUTION: Do not disassemble the flow control valve.