Component Inspection

Check Related component
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Select "Diagnostic Trouble Codes (DTCs)"mode and monitor "DTC Status" parameter.
4. Check if the DTC is erased while disconnecting related component one after another.
  Related component : IPM, ADM, DDM, FAM, RAM, IMS, Cluster module.
5. Is the DTC erased?
  YES
  
  Substitute with a known-good pertinent component and check for proper operation. If the problem is corrected, replace pertinent component and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  
  NO
  
  Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.