Monitor DTC Status

1. Connect scantool to Data Link Connector (DLC).
2. IG "ON".
3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F4 (DTAL) to check DTC's information from the DTCs menu.
4. Read "DTC Status" parameter.
   Fig 1: Scantool Display - DTC Status" Parameter

   Courtesy of HYUNDAI MOTOR CO.
5. Is parameter displayed "Present fault"?

YES 

• Go to "COMPONENT INSPECTION " procedure.

NO 

• Fault is intermittent caused by PCM memory was not cleared after repair. Erase DTC and drive the vehicle to satisfy the enable condition then, go to "COMPONENT INSPECTION " procedure.