FixVault
Home › Hyundai › 2007 › Santa Fe Limited, AWD › Repair and Diagnosis › Transmission › Automatic Transaxle System (A5HF1) › Automatic Transaxle Control System › Solenoid Valve › Installation

Solenoid Valve: Installation

  1. Install the solenoid valve (B-6EA) and the supporting bracket (A).
    CAUTION: Apply the ATF oil or White Vaseline to the O-ring not to be damaged.
    Fig 1: Identifying Solenoid Valve And Supporting Bracket
    G05348795Courtesy of HYUNDAI MOTOR CO.
  2. Connect the solenoid valve connector.
    CAUTION: When connecting the solenoid valve connector, check the connector for rust, dirt, or oil, then reconnect it.
  3. Continue to apply liquid gasket at application points at the oil pan with 02.5mm (0.098in) thickness.

    Liquid gasket Part name : Threebond 1281B

    Fig 2: Identifying Oil Pan Gasket Area
    G05348796Courtesy of HYUNDAI MOTOR CO.
  4. Tighten the mounting bolt with the specified torque after installing the oil pan.

    TORQUE :

    10~12Nm (1.0~1.2kgf.m, 7~8lb-ft)

  5. Install the drain plug and refill the transaxle fluid.

    TORQUE :

    35~45Nm (3.5~4.5kgf.m, 25~32lb-ft)

  6. Install the splash shield.
  7. Lower the vehicle and install the battery terminal.
About FixVault