FixVault
Home › Hyundai › 2007 › Santa Fe SE, FWD › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Immobilizer Control System › Immobilizer Control System › Immobilizer Control Unit › Replacement

Immobilizer Control Unit: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel (A) after removing side cover. (Refer to the "CRASH PAD ").
    Fig 1: Identifying Driver Crash Pad Lower Panel
    G05353659Courtesy of HYUNDAI MOTOR CO.
  3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a nut.
    Fig 2: Identifying Smartra Unit
    G05353660Courtesy of HYUNDAI MOTOR CO.
  4. Installation is the reverse of removal procedure.
About FixVault