FixVault
Home › Hyundai › 2008 › Azera GLS › Repair and Diagnosis › Body & Frame › Door Locks › Immobilizer Control System › DTC Codes › DTC P1676 SMARTRA Message Error › Component Inspection

Component Inspection

  1. Check status
    1. IGN "ON" & Engine "OFF" with key intended to register.
    2. Monitor the "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS" Parameter on the Scantool.

      Specification : 'LEARNT'

      Fig 1: Scan Tool Display - Key Status (Learnt)
      G05536979Courtesy of HYUNDAI MOTOR CO.
    3. Are "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS" Parameter within specifications?

      YES 

      • Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Go to "Check SMARTRA" procedure
  2. Check SMARTRA
    1. IGN "ON" & Engine "OFF"
    2. Neutralize "SMARTRA" and Register transponder key by scantool.
      NOTE: Pin code is required to Neutralize SMARTRA and to Register transponder key
    3. Are Neutralizing and Registering completed normally?

      YES 

      • Perform all the key teaching procedure with scantool. (All the keys must be retaught) and then, go to "VERIFICATION OF VEHICLE REPAIR " Procedure.
        NOTE: Never change the password after SMARTRA is neutralized with scantool Otherwise, Virgin TP only possible to register.

      NO 

      • Substitute with a known-good SMARTRA and check for proper operation.

        If the problem is corrected, replace SMARTRA and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

About FixVault