DTC C2380 Abs Valve Error: DTC Detecting Condition

DTC DETECTING CONDITION

Item	Detecting Condition	Possible cause
Detect Mode	Initial Check Outside the ABS control cycle Inside the ABS control cycle Diagnosis mode	Faulty HECU
Enable Conditions	If the valve relay is switched ON and corresponding solenoid driver OFF and the voltage of solenoid < 3.5 ± 0.5 V continuously for 56 ms, the failure is detected. If the valve relay is switched ON and corresponding solenoid driver ON and the voltage of solenoid > 1.5 ± 0.5 V continuously for 56 ms, the failure is detected.
Fail Safe	System down. The ABS/EBD functions are inhibited. The valve relay and all solenoids are prevented from being switched on. The ABS/EBD warning lamps are activated.