FixVault
Home › Hyundai › 2009 › Elantra Touring Standard › Repair and Diagnosis › Restraints › Air Bag, SRS › SRS Control Module (SRSCM) › Side Impact Sensor (SIS) › Installation

Side Impact Sensor (SIS): Installation

CAUTION:
  • Be sure to install the harness wires not to be pinched or interfered with other parts.
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

    Tightening torque 

    : 6.8 ~ 7.9 Nm (0.7 ~ 0.8 kgf.m, 5.0 ~ 5.8 lb.ft)

  2. Install the center pillar trim. (Refer to INTERIOR TRIM )
  3. Reconnect the negative battery cable.
  4. After installing the Side Impact Sensor, confirm proper system operation:
    • Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.
About FixVault