FixVault
Home › Hyundai › 2009 › Genesis 4.6 › Repair and Diagnosis › Body & Frame › Door Locks › Smart Key System › Troubleshooting › B1971 Parking Position Input Error › Component Inspection › Check Parking Position Switch

Check Parking Position Switch

  1. IG KEY OFF.
  2. Disconnect Parking Position switch connector.
  3. Measure resistance between one and the other connector when parking position switch ON and OFF.

    Specification:  Measurement 1 : Infinite (∞), Measurement 2 : About below 1 Ω

  4. Is the measured resistance within specification?

    YES 

    • Check poor connection between harness connector and Parking Position switch or IPM : Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector. Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known-good parking position switch and check for proper operation. If the problem is corrected, replace parking position switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
About FixVault