DTC P0708 Transaxle Range Switch - High Input: DTC Detecting Condition
DTC DETECTING CONDITION CHART
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
- Check for multiple signals
|
- Open or short in TRANSAXLE RANGE SWITCH
- Faulty Shift cable adjustment
- Faulty Inhibitor switch and Manual control lever position adjustment
- Faulty TRANSAXLE RANGE SWITCH
- Faulty PCM
|
| Enable Conditions |
- Engine state = "RUN"
- 11V ≤ Battery Voltage ≤ 16V
- TPS ≥ 3%
|
| Threshold value |
|
| Diagnostic Time |
|
| Fail Safe |
- Recognition as previous signal
- When signal is input "D" and "N" at the same time, TCM regards it as "N" RANGE
- After PCM/TCM Reset, If the if the PCM/TCM detects multiple signal or no signal, then it holds the 3rd gear position
|