FixVault

Automatic Transaxle: Removal

  1. Remove the air duct.
  2. Remove the battery.
  3. Remove the battery tray.
  4. Remove the air cleaner assembly.
  5. Remove the intercooler inlet pipe.
  6. Disconnect the connectors relevant to a transaxle.
    Fig 1: Locating Transaxle Connector (1 Of 2)
    G04811348Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Locating Transaxle Connector (2 Of 2)
    G04811349Courtesy of HYUNDAI MOTOR CO.
  7. Disconnect the ground earth wire.
  8. Remove the bolt (B) which mounts the clutch release cylinder (A) to the inhibitor switch.
    Fig 3: Locating Bolt And Clutch Release Cylinder
    G04924295Courtesy of HYUNDAI MOTOR CO.
  9. Detach the clutch release cylinder (B) clip (A).
    Fig 4: Locating Clutch Release Cylinder And Clip
    G04811351Courtesy of HYUNDAI MOTOR CO.
  10. Detach the hoses (A), loosening the oil cooler hose clamps.
    Fig 5: Locating Oil Cooler Hoses And Clamps
    G04811352Courtesy of HYUNDAI MOTOR CO.
  11. Using SST (09200-38001), support the engine.
    Fig 6: Supporting Engine Using SST (09200-38001)
    G04811353Courtesy of HYUNDAI MOTOR CO.
  12. Remove the transaxle mounting bracket bolts (A).
    Fig 7: Locating Transaxle Mounting Bracket Bolts
    G06207378Courtesy of HYUNDAI MOTOR CO.
    Fig 8: Locating Transaxle Mounting Bracket
    G04811355Courtesy of HYUNDAI MOTOR CO.
  13. Remove the transaxle upper mounting bolts (A).
    Fig 9: Locating Transaxle Upper Mounting Bolts
    G04811356Courtesy of HYUNDAI MOTOR CO.
  14. Remove the bolts which mount the transaxle to the front sub frame.
  15. Lift up the vehicle.
  16. After removing the oil drain plug (A), Drain the fluid.
    Fig 10: Locating Oil Drain Plug
    G04811357Courtesy of HYUNDAI MOTOR CO.
  17. Support the transaxle with a jack.
  18. Remove the steering column bolt (See STEERING COLUMN AND SHAFT ).
  19. Remove the driveshaft (See DRIVESHAFT AND AXLE GENERAL INFORMATION ).
  20. Remove the bolt (A) which mount the transaxle to the rear sub-frame.
    Fig 11: Locating Bolt Which Mount Transaxle To Rear Sub-Frame
    G04811358Courtesy of HYUNDAI MOTOR CO.
  21. Remove the sub-frame. If it is 4 wheel 1 drive vehicle (4WD), remove the propeller shaft first (See PROPELLER SHAFT ASSEMBLY ).
    Fig 12: Identifying Sub-Frame
    G06207383Courtesy of HYUNDAI MOTOR CO.
    Fig 13: Identifying Transaxle Lower Mounting Bolts
    G06207384Courtesy of HYUNDAI MOTOR CO.
  22. Remove the transaxle lower mounting bolts.
  23. Remove the transaxle assembly.