FixVault
Home › Hyundai › 2009 › Tucson SE, FWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle System › Troubleshooting › DTC Troubleshooting Index

DTC Troubleshooting Index

[Gasoline 2.0] 

DTC TROUBLESHOOTING INDEX

No DTC code Description MIL Remark
1 P0707 Transmission Range Sensor Circuit Low Input •  
2 P0708 Transmission Range Sensor Circuit High Input •  
3 P0711 Transmission Fluid Temperature Sensor "A" Circuit Range/Performance •  
4 P0712 Transmission Fluid Temperature Sensor "A" Circuit Low Input •  
5 P0713 Transmission Fluid Temperature Sensor "A" Circuit High Input •  
6 P0717 Input/Turbine Speed Sensor "A" Circuit No Signal •  
7 P0721 Output Speed Sensor (Pulse Generator B) Circuit Range/Performance •  
8 P0722 Output Speed Sensor (Pulse Generator B) Circuit No Signal •  
9 P0731 Gear 1 Incorrect Ratio •  
10 P0732 Gear 2 Incorrect Ratio •  
11 P0733 Gear 3 Incorrect Ratio •  
12 P0734 Gear 4 Incorrect Ratio •  
13 P0741 Torque Converter Clutch Circuit Performance or Stuck Off •  
14 P0743 Torque Converter Clutch Circuit Electrical •  
15 P0750 Shift Control Solenoid Valve "A" (Low-Reverse Brake Control Solenoid)-Open or Short •  
16 P0755 Shift Control Solenoid Valve "B" (Under Drive Solenoid)-Open or Short •  
17 P0760 Shift Control Solenoid Valve "C" (2nd Brake Control Solenoid) - Open or Short •  
18 P0765 Shift Control Solenoid Valve "D" (Over Drive Solenoid)-Open or Short •  
19 P0885 TCM Power Relay Open or Short (Ground) •  
20 U0001 CAN Communication Bus Off X  
21 U0100 Lost Communication With ECM/PCM "A" X  

[Gasoline 2.7] 

DTC TROUBLESHOOTING INDEX

No DTC code Description MIL Remark
1 P0560 System Voltage X  
2 P0605 Internal Control Module Read Only Memory (ROM) Error X  
3 P0703 Stop Lamp (Brake) Switch Circuit Malfunction X  
4 P0707 Transmission Range Sensor Circuit Low Input •  
5 P0708 Transmission Range Sensor Circuit High Input •  
6 P0711 Transmission Fluid Temperature Sensor "A" Circuit Range/Performance •  
7 P0712 Transmission Fluid Temperature Sensor "A" Circuit Low Input •  
8 P0713 Transmission Fluid Temperature Sensor "A" Circuit High Input •  
9 P0715 Input/Turbine Speed Sensor "A" Circuit No Signal •  
10 P0720 Output Speed Sensor (Pulse Generator B) Circuit No Signal •  
11 P0731 Gear 1 Incorrect Ratio •  
12 P0732 Gear 2 Incorrect Ratio •  
13 P0733 Gear 3 Incorrect Ratio •  
14 P0734 Gear 4 Incorrect Ratio •  
15 P0741 Torque Converter Clutch Circuit Performance or Stuck Off •  
16 P0742 Torque Converter Clutch Circuit Stuck On •  
17 P0743 Torque Converter Clutch Circuit Electrical •  
18 P0750 Shift Control Solenoid Valve "A" (Low-Reverse Brake Control Solenoid)-Open or Short •  
19 P0755 Shift Control Solenoid Valve "B" (Under Drive Solenoid)-Open or Short •  
20 P0760 Shift Control Solenoid Valve "C" (2nd Brake Control Solenoid) - Open or Short •  
21 P0765 Shift Control Solenoid Valve "D" (Over Drive Solenoid)-Open or Short •  
22 P0885 TCM Power Relay Open or Short (Ground) •  
23 P1500 Vehicle Speed Sensor Signal Circuit Malfunction X  
24 U0001 CAN Communication Bus Off X  
25 U0100 Lost Communication With ECM/PCM "A" X  

*: Malfunction Indication Lamp (MIL) will not be turned ON or blinked by only TCM DTCs. If MIL is on or blinking, check the fuel or emission system.

Service Data List (with Scan Tool) 

SERVICE DATA LIST (WITH SCAN TOOL)

No. Item Name Unit Data Data Description Failure
1 ENGINE RPM rpm 700 rpm Current Engine rpm 0 rpm
2 VEHICLE SPEED km/h 0km/h Current Vehicle speed 0km/h
3 THROTTLE P.SENSOR % 12.5% Current TPS open angle 0%
4 INPUT SPEED (PG-A) rpm 700 rpm Input speed rpm. Always output rpm when turning start ON 0 rpm
5 OUTPUT SPEED (PG-B) rpm 0 rpm Output speed rpm. Always output rpm when driving 0 rpm
6 DCC (TCC) SOLENOID DUTY % 0% Control 0% → 100% when operating Damper Clutch  
7 DAMPER CLUTCH SLIP rpm 260 rpm Current Damper clutch slip ratio 0 rpm
8 LR SOLENOID DUTY % 100% Control 100% → 0% when operating brake 0%
9 UD SOLENOID DUTY % 100% Control 100% → 0% when operating clutch 0%
10 2ND SOLENOID DUTY % 100% Control 100% → 0% when operating clutch 0%
11 OD SOLENOID DUTY % 100% Control 100% → 0% when operating clutch 0%
12 OIL TEMPERATURE °C 40°C Current Oil temperature 80°C
13 SHIFT POSITION N.P.REV/ 1stG/.../5 th G D Current shift position P, N
14 TRANSAXLE RANGE SW P.N/R/D/ SPORTS D Current shift lever position P, N
15 HOLD/STD SWITCH -/-/HOLD/ STD -   -
16 A/CON SWITCH OFF/ON/-/ NOT SUP-P OFF -  
17 IDLE STATUS OFF/ON/-/ NOT SUP-P ON When idling, ON  
18 BRAKE SWITCH OFF/ON/-/ NOT SUP-P ON When braking, ON  
19 CRUISE SWITCH OFF/ON/-/ NOT SUP-P      
20 SPORT MODE SELECT SW OFF/ON/-/ NOT SUP-P ON When selecting sport mode, ON  
21 SPORT MODE UP SW OFF/ON/-/ NOT SUP-P ON When Selecting Sport mode up, ON  
22 SPORT MODE DOWN SW OFF/ON/-/ NOT SUP-P ON When selecting sport mode down, ON  
23 A/T CONTROL RELAY VOL-T V 12.9V   0V
24 ENGINE TORQUE % 20%    
25 HIVEC MODE A/B/C/D/-/ F LI_ A/B/C/D is control mode, F is release mode F

HIVEC - SAT (Siemens Adaptive Transmission Control) Mode (Shift Pattern) 

HIVEC - SIEMENS ADAPTIVE TRANSMISSION CONTROL MODE (SHIFT PATTERN)

Shift pattern Description (Help) Scan Display
ECONOMY Economy Driver shift pattern for flat road A
MEDIUM Shift pattern for medium road B
SPORTS Shift pattern for sporty road C
LOAD 1 Shift pattern for low land, slow grade and slope D
LOAD 3 Shift pattern for downhill road F

Actuator Inspection 

ACTUATOR INSPECTION

No Item Name Actuator Driving Condition
1 LRSOLENOID (SCSVA) Driving solenoid valve indicated by Scan tool for 5 sec.
(Other solenoid valve is not continuity)
Blinking for 3 sec.
  1. IG Key ON
  2. Inhibitor SW normal
  3. P range
  4. Vehicle speed 0 km/h
  5. Engine stop
  6. No failure
  7. TPS < 1V
2 UD SOLENOID (SCSV B)
3 2NDSOLENOID (SCSVC)
4 OD SOLENOID (SCSV D)
5 TORQUE CONVERTER SOLENOID VALVE
6 1ST SHIFT INDICATOR LAMP
7 2ND SHIFT INDICATOR LAMP
8 3RD SHIFT INDICATOR LAMP
9 4TH SHIFT INDICATOR LAMP
10 A/T CONTROL RELAY OFF for 3 sec.  
11 INTELLIGENT SHIFT PROHIBIT Prohibit until IG off  
About FixVault