Control Circuit Inspection

Ignition "OFF".
Disconnect front HO2S harness connector.
Measure voltage between terminal 1 of the HO2S harness connector and chassis ground.
Specification: Approx. 2~3V.

Fig 1: Measuring Voltage Between HO2S Harness Connector Terminal 1 And Chassis Ground
Courtesy of HYUNDAI MOTOR CO.
Measure resistance between terminals 1 and 2,3,4,5,6 of the HO2S harness connector.
Specification: Infinite

Fig 2: Measuring Resistance Between Terminals 1 And 2, 3, 4, 5, 6 Of HO2S Harness Connector
Courtesy of HYUNDAI MOTOR CO.
Is the measured data within specification?
YES
- Check for open or short circuit in HO2S harness connector. Refer to "Signal Waveform & Data " procedure in "General Information". Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.