FixVault
Home › Hyundai › 2011 › Genesis 4.6 › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System (Fuel System (G8BA - GSL 4.6L)) › Engine Control Module (ECM) › Removal

Engine Control Module (ECM): Removal

NOTE: In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure together (Refer to TEACHING PROCEDURES ).
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the cover
  3. Disconnect the ECM connector (A) and the TCM connector (B).
  4. Remove the ECM & TCM bracket installation bolts (C) and nut (D).
    5. Fig 1: Identifying TCM And ECM Connectors
    G06106245Courtesy of HYUNDAI MOTOR CO.
  5. After removing the installation bolts (A), remove the ECM (B) from the bracket.
    Fig 2: Identifying ECM Bracket Bolts
    G06106124Courtesy of HYUNDAI MOTOR CO.
About FixVault