FixVault
Home › Hyundai › 2011 › Genesis Coupe 2.0T, Standard › Repair and Diagnosis › Restraints › Air Bag, SRS › Airbag Module › Side Airbag (SAB) Module › Repair Procedures › Installation

Repair Procedures: Installation

CAUTION: Be sure to install the harness wires so they are not pinched or interfering with other parts.
NOTE:
  • Do not open the lid of the side airbag cover.
  • Use new mounting nuts when you replace a side airbag.
  • Make sure that the airbag assembly cover is installed properly. Improper installation may prevent proper deployment.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Place a Side Airbag (SAB) on the side airbag frame and tighten the side airbag mounting nuts (2EA).

    Tightening torque: 

    5.9 ~ 7.8 Nm (0.6 ~ 0.8 kgf.m, 4.3 ~ 5.8 lb.ft)

    Fig 1: Identifying SAB Module & Mounting Nuts
    G06513298Courtesy of HYUNDAI MOTOR CO.
  4. Install the new seat back cover. (Refer to SEAT )
  5. Install the front seat assembly, and then connect the Side Airbag (SAB) harness connector.
  6. Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
  7. Reconnect the battery negative cable.
  8. After installing the Side Airbag (SAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
About FixVault