Repair Procedures: Replacement

Remove the front driveshaft.
(Refer to "FRONT DRIVESHAFT ")
Remove the TJ joint assembly.
(Refer to "TJ JOINT ")
Remove the dynamic damper.
(Refer to "DYNAMIC DAMPER ")
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

Fig 1: Removing BJ Boot Bands Using Flat-Tipped Screwdriver
Courtesy of HYUNDAI MOTOR AMERICA
Remove the BJ boot.
Install in the reverse order of removal.
CAUTION:
- Do not disassemble the BJ assembly.
- Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
- The boot band should be replaced with a new one.