FixVault
Home › Hyundai › 2012 › Elantra Touring GLS, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 69 (Lighting System) › Flasher Unit › Inspection

Flasher Unit: Inspection

WARNING: This page is about a different car, the 2011 Hyundai Elantra Touring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel (A).
    Fig 1: Identifying Driver Crash Pad Lower Panel
    G06145591Courtesy of HYUNDAI MOTOR CO.
  3. Remove the driver crash pad reinforcing panel (A) after loosening 5 bolts.
    Fig 2: Identifying Driver Crash Pad Reinforcing Panel And Bolts
    G06145592Courtesy of HYUNDAI MOTOR CO.
  4. Remove the flasher unit (A) after loosening the bolt and disconnecting the connector.
    Fig 3: Identifying Flasher Unit
    G05365593Courtesy of HYUNDAI MOTOR CO.
  5. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3.
  6. Connect the two turn signal lamps in parallel to terminals 1 and 3. Check that the bulbs turn on and off.
    NOTE: The turn signal lamps should flash 60 to 120 times per minute. If one of the front or rear turn signal lamps has an open circuit, the number of flashes will be more than 120 per minute. If operation is not as specified, replace the flash unit.
About FixVault