FixVault
Home › Hyundai › 2012 › Equus Signature › Repair and Diagnosis › Restraints › Air Bag, SRS › Airbag Modules & Clock Spring › Driver Airbag (DAB) Module and Clock Spring › Repair Procedures › Installation

Repair Procedures: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
  3. Connect the clock spring harness connector and horn harness connector to the clock spring.
  4. Set the clock spring on neutral position and after turning the front wheels to the straight-ahead position, install the clock spring.
    NOTE: As described direction on the clock spring warning label, align the centerline when adjusting the setting mark (> <).
  5. Install the steering wheel column cover and the steering wheel. (Refer to STEERING COLUMN & SHAFT )
  6. Connect the steering wheel remote control switch connector.
  7. Connect the Driver Airbag (DAB) module connector and horn connector, and then install the Driver Airbag (DAB) module on the steering wheel.
  8. Secure the Driver Airbag (DAB) with the new mounting bolts.

    Tightening torque: 

    7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

    Fig 1: Identifying Driver Airbag With Mounting Bolts
    G08830836Courtesy of HYUNDAI MOTOR AMERICA
  9. Connect the battery negative cable.
  10. After installing the airbag, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    2. Make sure horn button works.
About FixVault