FixVault
Home › Hyundai › 2012 › Santa Fe SE, FWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - G3.5 DOHC › VCM Position Sensor › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold. (Refer to INTAKE AND EXHAUST SYSTEM .)
  3. Remove the installation screws (A), and then remove the VCM position sensor.
    Fig 1: Locating VCM Position Sensor Screws
    G06844932Courtesy of HYUNDAI MOTOR CO.
About FixVault