Repair Procedures: Installation
NOTE:
When replacing the TCM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used TCM]
- Perform "Neutral mode" procedure with GDS. (Refer to TEACHING MODE PROCEDURE DESCRIPTION (STEP BY STEP) )
- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]
- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
- Installation is reverse of removal.
TCM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
TCM bracket installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching" procedure together (Refer to IMMOBILIZER SYSTEM DIAGNOSIS - HEV or "BUTTON ENGINE START SYSTEM " ).
- Installation is reverse of removal.