Repair Procedures: Removal

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the resonator and the air intake hose.
(Refer to "AIR CLEANER ")
Disconnect the ETC module connector (A).

Fig 1: Electronic Throttle Control Module Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the installation bolts, and then remove the ETC module (A) from the engine.

Fig 2: Electronic Throttle Control Module
Courtesy of HYUNDAI MOTOR AMERICA