Repair Procedures - Non-Turbo: Disassembly

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

Remove the alternator cover (A).

Fig 1: Identifying Rear Cover
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting bolts (A) and disconnect the brush holder assembly (B).

Fig 2: Identifying Brush Holder Assembly With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the slip ring guide (A).

Fig 3: Removing Slip Ring Guide
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- When installing, replace with new OAD cap.
Remove the nut and pulley (A).

Fig 4: Removing Overrunning Alternator Decoupler Pulley Using Special Tool
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the 4 through bolts (A).

Fig 5: Identifying Through Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rotor (A) and cover (B).

Fig 6: Identifying Rotor And Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Reassembly is the reverse of disassembly.