Repair Procedures: Installation

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

Install the new gasket and water pump (A).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 1: Water Pump
Courtesy of HYUNDAI MOTOR AMERICA
Install the water pump pulley (A).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 2: Water Pump Pulley
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Tighten the bolts diagonally when installing.
Remove the drive belt.
(Refer to "DRIVE BELT ")
Fill with engine coolant.
Start engine and check for leaks.
Recheck engine coolant level.