FixVault
Home › Hyundai › 2014 › Accent GLS, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 10 (Ignition Switch Assembly) › Repair procedures › Replacement

Repair procedures: Replacement

WARNING: This page is about a different car, the 2012 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel. (Refer to the "Crash Pad ")
  3. Remove the ignition switch (A) after loosening the screw with IG ON and disconnecting the 6P connector.
    Fig 1: Identifying Ignition Switch
    G06847963Courtesy of HYUNDAI MOTOR CO.
  4. Remove the steering column cover. (Refer to the Steering Column And Shaft )
  5. Remove the door warning switch and key illumination lamp (A) after disconnecting the 6P connector.
    Fig 2: Identifying Key Illumination Lamp
    G06847964Courtesy of HYUNDAI MOTOR CO.
  6. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.
    Fig 3: Removing Key Lock Cylinder After Pushing Lock Pin
    G06847965Courtesy of HYUNDAI MOTOR CO.
  7. Installation is the reverse of removal procedure.
About FixVault