FixVault
Home › Hyundai › 2014 › Accent GLS, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 3 (Airbag Modules & Clock Spring) › Side Airbag (SAB) Module › Repair Procedures › Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2012 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure that the harness is installed and routed properly to prevent damage to the wiring.
NOTE:
  • Do not open the lid of the side airbag cover.
  • Make sure that the seatback cover is installed properly. Improper installation may prevent the proper deployment.
  1. Remove ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Install the new seat back assembly.

    (Refer to FRONT SEAT .)

  4. Install the seat assembly.

    (Refer to FRONT SEAT .)

  5. Recline and slide the front seat forward fully, make sure the harness wires are not pinched or interfering with other parts.
  6. Reconnect the battery negative cable.
  7. After installing the Side Airbag (SAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
About FixVault