Blind Spot Detection DTCS
WARNING: This page is about a different car, the 2014 Hyundai Santa Fe Sport and 2013 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
BLIND SPOT DETECTION DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC C110117 | Battery Voltage High |
| DTC C110216 | Battery Voltage Low |
| DTC C120A11 | LED Right Circuit Short to Ground |
| DTC C120B15 | LED Right Circuit Short to Battery or Open |
| DTC C120C11 | LED Left Circuit Short to Ground |
| DTC C120D15 | LED Left Circuit Short to Battery or Open |
| DTC C150101 | Switch Failure |
| DTC C160A88 | BSD Local CAN bus off |
| DTC C161187 | CAN Time-out EMS |
| DTC C161287 | CAN Time-out TCU |
| DTC C161381 | CAN signal error EMS |
| DTC C161688 | CAN Bus OFF (C-CAN) |
| DTC C162587 | CAN Time-out ABS/ESC(ESP) |
| DTC C162887 | CAN Time-out Cluster |
| DTC C164681 | CAN Message Failure - TCU |
| DTC C167181 | Signal Yaw Rate or Acceleration AX or Acceleration AY or Brake pressure State not valid |
| DTC C170A11 | Activation Switch LED Circuit short to ground |
| DTC C170B12: | Activation Switch LED Circuit short to battery or open |
| DTC C170C04 | ECU Hardware error (REAR RIGHT) |
| DTC C170D04 | ECU Hardware error (REAR LEFT) |
| DTC C174342 | Software version LH/RH unmatching |
| DTC C181287 | CAN Time-out Gateway |
| DTC C270254 | Control Module Missing Calibration |
| DTC C270354 | Control Module Slave Missing Calibration |