Heater Control Unit Replacement

CAUTION:

A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad center garnish (A).

Fig 1: Crash Pad Center Garnish
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the center fascia panel (A).

Fig 2: Loosening Center Fascia Panel Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 3: Connector
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the audio assembly (A).

Fig 4: Loosening Audio Assembly Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors.

Fig 5: Connectors
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the heater control unit (A).

Fig 6: Loosening Heater Control Unit Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A) and hose (B).

Fig 7: Connectors And Hose
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damaged clips.