Repair procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Installation is the reverse of removal.
NOTE:
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
- Install the guide member (A) of the select cable (B).
  
  Fig 1: Guide Member And Cable
  Courtesy of HYUNDAI MOTOR AMERICA
- Adjust the slide clip (B) to fit it into the select lever pin (A) and install the snap pin (C).
Fig 2: Installing Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA