FixVault
Home › Hyundai › 2014 › Elantra Limited › Repair and Diagnosis › External Pages › Different car › Section 15 (Manual Transaxle Control System) › Repair procedures › Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2013 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

Shift Lever Assembly Replacement 

  1. Remove the floor Interior console assembly.

    (Refer to "CONSOLE " )

  2. Remove the cover (A).
    Fig 1: Shift Lever Cover
    G10234962Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the select cable (B) by removing the snap pin (A).
    Fig 2: Select Cable And Snap Pin
    G10234963Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the shift lever assembly (B) by removing the bolts (A-4ea).

    Tightening torque: 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 3: Shift Lever Assembly Bolts
    G10234964Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the shift cable (B) by removing the clip (A).
    Fig 4: Shift Cable And Clip
    G10234965Courtesy of HYUNDAI MOTOR AMERICA
    Fig 5: Shift Lever Assembly
    G10234966Courtesy of HYUNDAI MOTOR AMERICA
  6. Installation is the reverse of removal.
    NOTE:
    • Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.

Shift Cable Replacement 

  1. Remove the floor Interior console assembly.

    (Refer to "CONSOLE " )

  2. Remove the cover (A).
    Fig 6: Shift Lever Cover
    G10234967Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the select cable (B) by removing the snap pin (A).
    Fig 7: Select Cable And Snap Pin
    G10234968Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the shift lever assembly (B) by removing the bolts (A-4ea).

    Tightening torque: 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 8: Shift Lever Assembly Bolts
    G10234969Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the shift cable (B) by removing the clip (A).
    Fig 9: Shift Cable And Clip
    G10234970Courtesy of HYUNDAI MOTOR AMERICA
    Fig 10: Shift Lever Assembly
    G10234971Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the retainer (A) and nuts (B-2ea).

    Tightening torque: 

    11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

    Fig 11: Retainer And Nuts
    G10234972Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the select and shift cable assembly (B) after removing the pin (A).
    Fig 12: Shift Cable Assembly And Pin
    G10234973Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the shift cable and select cable at cabin room.
About FixVault