FixVault
Home › Hyundai › 2014 › Elantra Sport, Automatic Trans › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Ignition Switch Assembly › Repair Procedures › Removal

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Refer to "CRASH PAD ")

  3. Remove the steering column upper and lower shrouds.

    (Refer to "CRASH PAD ")

  4. Remove the wiper switch.

    (Refer to MULTIFUNCTION SWITCH

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector.
  6. Remove the key warning/immobilizer connector (A).
    Fig 1: Warning/Immobilizer Connector And Key Illumination
    G10244352Courtesy of HYUNDAI MOTOR AMERICA
  7. After loosening the screw, remove the key warning switch and key Illumination (B).
  8. Pushing lock pin with key ACC.
  9. Remove the key lock cylinder (A).
    Fig 2: Ignition Lock Cylinder
    G10244353Courtesy of HYUNDAI MOTOR AMERICA
About FixVault