FixVault
Home › Hyundai › 2014 › Genesis Coupe 3.8 R-Spec, Standard Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 3.8L › Crankshaft Position Sensor (CKPS) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the air cleaner assembly (Refer to INTAKE AND EXHAUST SYSTEM (ENGINE MECHANICAL) - 3.8L ).
  3. Disconnect the crankshaft position sensor connector (A).
  4. Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
Fig 1: Identifying Crankshaft Position Sensor Connector & Installation Bolt
G00540442Courtesy of HYUNDAI MOTOR CO.
About FixVault