Repair Procedures: Disassembly

Remove the rear cover (A) after removing nuts (B).

Fig 1: Identifying Rear Cover & Nuts
Courtesy of HYUNDAI MOTOR CO.
Remove the mounting bolts (A) and the regulator assembly (B).

Fig 2: Identifying Mounting Bolts & Regulator Assembly
Courtesy of HYUNDAI MOTOR CO.
Remove the slip ring guide (A) after pulling it.

Fig 3: Identifying Slip Ring Guide
Courtesy of HYUNDAI MOTOR CO.
Remove the OAD (Overrunning Alternator Decoupler) cap.
NOTE:
When installing, replace with new OAD cap.
Remove the OAD (Overrunning Alternator Decoupler) pulley (A) using the special tool.

Fig 4: Identifying OAD Pulley & SST
Courtesy of HYUNDAI MOTOR CO.
Unsolder the 3 stator leads (A).

Fig 5: Identifying 3 Stator Leads
Courtesy of HYUNDAI MOTOR CO.
Remove the 4 through bolts (A).

Fig 6: Identifying Through Bolts
Courtesy of HYUNDAI MOTOR CO.
Disconnect the rotor (A) and housing (B).

Fig 7: Identifying Rotor & Housing
Courtesy of HYUNDAI MOTOR CO.