FixVault
Home › Hyundai › 2014 › Tucson GLS, FWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle Control System - 2.0L › Transaxle Oil Temperature Sensor › Repair Procedures › Removal

Repair Procedures: Removal

  1. Remove the air cleaner assembly and air duct.

    (Refer to INTAKE MANIFOLD )

  2. Remove the battery and battery tray.

    (Refer to BATTERY )

  3. Remove the under cover.

    (Refer to "ENGINE ROOM UNDER COVER ")

  4. Remove the valve body.

    (Refer to VALVE BODY )

  5. Disconnect the solenoid valve connector (A).
    Fig 1: Disconnecting Solenoid Valve Connector
    G09815347Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the solenoid valve main connector mounting clip (A) after removing the bolt.
    Fig 2: Identifying Solenoid Valve Main Connector Mounting Clip
    G09815348Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the solenoid valve main connector (A).
    Fig 3: Locating Solenoid Valve Main Connector
    G09815349Courtesy of HYUNDAI MOTOR AMERICA
  8. Disconnect the input & output speed sensor connector (A) after press the lock from the solenoid valve main wiring.
    Fig 4: Identifying Input And Output Speed Sensor Connector
    G09815350Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the solenoid valve main wiring & oil temperature sensor after loosening the main connector bolt (A).
    Fig 5: Identifying Main Connector Bolt
    G09815351Courtesy of HYUNDAI MOTOR AMERICA
About FixVault