Repair Procedures: Removal

Set shift lever to "N" position.
Remove the air duct.
(Refer to AIR CLEANER )
Remove the battery and the battery tray.
(Refer to BATTERY )
Disconnect the inhibitor switch connector (A).
Remove the shift cable mounting nut (B).
Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fig 1: Identifying Inhibitor Switch Connector And Shift Cable Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the manual control lever (B) and the washer after removing a nut (A).
Tightening torque: 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

Fig 2: Identifying Manual Control Lever And Nut
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Use a SST (09480-A3800) or 0.1969 in. (5 mm) bolt, fix the inhibitor manual control lever in the "N" jig hole (A) when you assemble the inhibitor (B).

Fig 3: Fixing Inhibitor Manual Control Lever In "N" Jig Hole
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor assembly (A) after removing the bolts (2 ea).
Tightening torque: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 4: Identifying Inhibitor Assembly
Courtesy of HYUNDAI MOTOR AMERICA