FixVault
Home › Hyundai › 2014 › Veloster Base, Automatic DCT Trans › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel Delivery System - Non-Turbo › Fuel Pump › Repair Procedures › Removal

Repair Procedures: Removal

  1. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " .
  2. Remove the rear seat [LH] (Refer to "Seat ").
  3. Remove the fuel pump service cover (A).
    Fig 1: Fuel Pump Service Cover
    G08807105Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel pump connector (A).
  5. Disconnect the fuel feed tube quick connector (B).
  6. Disconnect the fuel tank pressure sensor connector (C).
  7. Disconnect the vapor tube quick-connector (D).
  8. Remove the plate cover (E) after removing the installation bolts, and then remove the fuel pump from the fuel tank.
    Fig 2: Fuel Pump, Feed Tube, Pressure Sensor & Vapor Tube Connectors
    G08807106Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Fuel Pump Assembly
    G08807107Courtesy of HYUNDAI MOTOR AMERICA
About FixVault