FixVault
Home › Hyundai › 2014 › Veloster Base, Standard Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - Non-Turbo › Camshaft Position Sensor (CMPS) › Repair procedures › Removal › Bank 1/Exhaust

Bank 1/Exhaust

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the hanger and the protector.
  4. Remove the installation bolt (B), and then remove the sensor.
    Fig 1: Camshaft Position Sensor Connector & Bolt (Bank 1 / Exhaust)
    G08807038Courtesy of HYUNDAI MOTOR AMERICA
About FixVault