FixVault
Home › Hyundai › 2014 › Veloster Base, Standard Trans › Repair and Diagnosis › External Pages › Different variant/trim › Section 19 (Dual Clutch Transmission Control System) › Input Speed Sensor 1 › Repair Procedures › Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the under cover.
  2. Disconnect the input shaft speed sensor connector (A).
    Fig 1: Identifying Input Shaft Speed Sensor Connector
    G09135540Courtesy of HYUNDAI MOTOR AMERICA
  3. Loosen the mounting bolt and then remove the input shaft speed sensor (B).
    Fig 2: Identifying Input Shaft Speed Sensor Mounting Bolt
    G09135541Courtesy of HYUNDAI MOTOR AMERICA
About FixVault