FixVault
Home › Hyundai › 2015 › Accent GLS, Automatic Trans › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System/Electronic Stability Control System Diagnosis › DTC C1237: Primary Pressure Sensor-Signal › Component Inspection

Component Inspection

  1. IG "OFF".
  2. IG "ON".
  3. Connect GDS and select "Diagnostic Trouble Codes (DTC)"  mode.
  4. Using a GDS, Clear DTC.
  5. Check if the pressure sensor's service data shows '0 bar' on the GDS while not pressing the brake pedal.
  6. Use the GDS and check that the pressure sensor value rises while pressing the brake pedal.
  7. Is the pressure sensor's data unusually shown?

    YES 

    • Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NOTE: *In a case of replacing HECU, operate following functions
    1. "Steering Angle Sensor Calibration" for steering angle sensor offset correction (refer to C1261) - ESP only
    2. "Longitudinal Sensor Calibration" for Longitudinal sensor offset correction (refer to C1285) - ESP only
    3. "Variant Coding" for type recognition (refer to C1702 )

    NO 

About FixVault