Repair Procedures: Disassembly

Remove the rear cover (A) after removing nuts (B).

Fig 1: Removing Nuts & Rear Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the mounting bolts (A) and the regulator assembly (B).

Fig 2: Removing Mounting Bolts & Regulator Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the slip ring guide (A) after pulling it.

Fig 3: Removing Slip Ring Guide
Courtesy of HYUNDAI MOTOR AMERICA
Remove the OAD (Overrunning Alternator Decoupler) cap.
NOTE:
- When installing, replace with new OAD cap.
Remove the OAD (Overrunning Alternator Decoupler) pulley (A) using the special tool.

Fig 4: Removing OAD Pulley
Courtesy of HYUNDAI MOTOR AMERICA
Unsolder the 3 stator leads (A).

Fig 5: Identifying Stator Leads
Courtesy of HYUNDAI MOTOR AMERICA
Remove the 4 through bolts (A).

Fig 6: Removing Through Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rotor (A) and housing (B).

Fig 7: Identifying Rotor And Housing
Courtesy of HYUNDAI MOTOR AMERICA