De-normalization (Memory reset)

Under conditions below, ECU turns to de-normalized status. After de-normalization, auto up and safety function shall not be operated. In order to make these function active again, ECU should go through the normalization process.

• De-normalization conditions:

1. Continuous 15 times reverses
2. Power off during motor operation
3. Driver side door opened and window glass is at the bottom (hard stop position) with IGN on, IGN off → within 2 sec, IGN on → Press Manual Down switch 3 times within 5 sec → De-normalization

   Door and Glass status	IGN status	Input time	IGN status	Switch input status			Switch input times	Normalization status
   				Re-input time	IGN status	Switch input
   Driver side door opened, Window glass is bottom with IGN on (Hard stop)	IGN Off	T≤2 sec	IGN On	T≤5 sec	IGN On	Press and release Manual down switch	3 times	De-normalization