FixVault
Home › Hyundai › 2015 › Genesis Coupe 3.8, Automatic Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 3.8L › Fuel Tank Pressure Sensor (FTPS) › Repair procedures › Removal

Repair procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the floor mat in the trunk (Refer to "REAR SEAT " ).
  3. Remove the service cover (A).
    Fig 1: Service Cover
    G10493841Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel tank pressure sensor connector (A).
  5. Remove the fuel tank pressure sensor after removing the installation bolt.
    Fig 2: Fuel Tank Pressure Sensor Connector
    G10493842Courtesy of HYUNDAI MOTOR AMERICA
About FixVault