Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
Disconnect the accelerator position sensor connector (A).
Remove the upper mounting cap (B), and then remove the mounting nut (C).
Remove the lower mounting cap (D), and then remove the mounting nut (E).

Fig 1: Removing Accelerator Position Sensor And Upper/Lower Mounting Cap

Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Disconnecting Accelerator Position Sensor Connector

Courtesy of HYUNDAI MOTOR AMERICA