FixVault
Home › Hyundai › 2015 › Tucson SE, FWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 2.4L › Crankshaft Position Sensor (CKPS) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A).
    Fig 1: Identifying Crankshaft Position Sensor Connector
    G10631547Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the protector (A).
    Fig 2: Identifying Protector
    G10631548Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolt (A), and then remove the crankshaft position sensor.
    Fig 3: Identifying Crankshaft Position Sensor Installation Bolt
    G10631549Courtesy of HYUNDAI MOTOR AMERICA
About FixVault