Repair Procedures: Adjustment
WARNING: This page is about a different car, the 2016 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the lower crash pad. (Refer to CRASH PAD )
- Remove the knee airbag. (Refer to AIRBAG MODULE )
- Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance : 1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)
- If the gap between stop lamp switch and bracket is not 1.0~2.0mm (0.04~0.08in), check the mounting clip and other part of around stop lamp.
- If there is normal, remove the stop lamp switch and then install again.