FixVault
Home › Hyundai › 2015 › Veloster Turbo, Automatic Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 1.6L T-GDI › Camshaft Position Sensor (CMPS) › Repair Procedures › Removal

Repair Procedures: Removal

WARNING:
  • DON'T remove the Camshaft Position Sensor while the Engine is running or right after Engine is turned OFF. The part and Engine Oil is HOT and can cause burns.

[Bank 1/Intake] 

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Camshaft Position Sensor Connector (A).
  3. Remove the Installation Bolt (B) and remove the Sensor.
Fig 1: Camshaft Position Sensor Connector And Installation Bolt (Bank 1/Intake) Location
G10604563Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Exhaust] 

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Camshaft Position Sensor Connector (A).
  3. Remove the Installation Bolt (B), and then remove the Sensor.
Fig 2: Camshaft Position Sensor Connector And Installation Bolt (Bank 1/Exhaust) Location
G10604564Courtesy of HYUNDAI MOTOR AMERICA
About FixVault