Floor Console Replacement: [A/T]

CAUTION:

A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad center garnish (A).

Fig 1: Crash Pad Center Garnish
Courtesy of HYUNDAI MOTOR AMERICA
Remove the gear knob (A) and gear boots (B) pull both of it up.

Fig 2: Gear Knob And Boots
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the console upper cover (A).

Fig 3: Console Upper Cover And Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 4: Multimedia Jack Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the parking brake cover (A).

Fig 5: Parking Brake Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the console tray mat (A).

Fig 6: Console Tray Mat
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and bolts, then remove the floor console assembly (A).

Fig 7: Floor Console Assembly, Mounting Screws And Bolts
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, bolts, clips, then remove the console side cover (A).

Fig 8: Console Side Cover, Mounting Screws, Bolts And Clips
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 9: Floor Console Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damaged clips.