FixVault
Home › Hyundai › 2016 › Equus Signature › Repair and Diagnosis › Body & Frame › Seats › Front Seat › Front Seat Assembly › Repair procedures › Replacement

Repair procedures: Replacement

  1. Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.
    Fig 1: Removing Safety Belt
    G10386751Courtesy of HYUNDAI MOTOR AMERICA
  2. Remove the front seat track mounting cover.
  3. After loosening the mounting bolts and nuts, remove the front seat assembly (A).

    Tightening torque: 

    Bolts: 34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)

    Nuts: 23.5 ~ 35.3 N.m (2.4 ~ 3.6 kgf.m, 17.4 ~ 26.0 lb-ft)

    Fig 2: Front Seat Assembly
    G10386752Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the front seat integration connector (A).

    [Driver's] 

    Fig 3: Front Seat Integration Connector (Driver)
    G10386753Courtesy of HYUNDAI MOTOR AMERICA

    [Passenger's] 

    Fig 4: Front Seat Integration Connector (Passenger)
    G10386754Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the rear monitor image cable connector (A).
    Fig 5: Rear Monitor Image Cable Connector
    G10386755Courtesy of HYUNDAI MOTOR AMERICA
  6. Install in the reverse order of removal.
    IMPORTANT:

    SEAT MOUNTING BOLT INSTALLATION PROCEDURE 

    • Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
    • Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
    • Set the seat into the most rearward position. Check the front mounting bolt completely.
    • Check that the seat operates to and fro smoothy and the locking portion locks properly.
About FixVault